Spectrum-controls 1769sc-HART Modules Manual do Utilizador Página 59
- Página / 186
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Chapter 4: Module Data, Status, and Configuration
User's Manual 0300215-03 Rev. A
6-9
Table 6-5 (Filter Frequency and Step Response)
Filter Frequency
Step Response
1
28.5 Hz
108 ms
50 Hz 62 ms
60 Hz
52 ms
300 Hz
12 ms
360 Hz
10 ms
1
The channel update time is equal to the channel step respose.
Channel Cut-Off Frequency
The filter cut-off frequency, -3 dB, is the point on the frequency response curve where
frequency components of the input signal are passed with 3 dB of attenuation. The
following table shows cut-off frequencies for the supported filters.
Table 6-6 (Filter Frequency versus Channel Cut-off Frequency)
Filter Frequency
Cut-off Frequency
Rejection
28.5 Hz
2.3 Hz 67 db @ 50/60 Hz
50 Hz 4.0 Hz 96 db @ 50 Hz
60 Hz 4.7 Hz 96 db @ 60 Hz
300 Hz
24 Hz
25 db @ 50 Hz
360 Hz 28 Hz 25 db @ 60 Hz
All input frequency components at or below the cut-off frequency are passed by the
digital filter with less than 3 dB of attenuation. All frequency components above the cut-
off frequency are increasingly attenuated as shown in Figure 6-2 (Frequency Response).
- Compact™ I/O 1
- Isolated HART 1
- Analog Module 1
- Table of Contents 3
- Preface 7
- Conventions 8
- Used in This 8
- Chapter 1 9
- Module Overview 9
- Do No t Remov e RTB Un der 10
- Power Unless Area is Non 10
- Hazardous 10
- Section 1.5 11
- System 11
- Overview 11
- 1.5.1 System Operation 11
- Section 1.6 12
- Module 12
- Operation 12
- Chapter 2 13
- Quick Start for Experienced 13
- Chapter 3 19
- Installation and Wiring 19
- 3.3.3 Remove Power 21
- 3.3.4 Selecting a Location 21
- Section 3.4 22
- System Assembly 22
- Section 3.5 23
- Mounting 23
- 3.5.1 Minimum Spacing 23
- 3.5.2 Panel Mounting 23
- 3.5.3 DIN Rail Mounting 24
- 3.7.2 Terminal Door Label 26
- 3.7.5 Wiring the Module 27
- 3.7.6 Wiring Diagram 28
- 3.7.7 Calibration 28
- Chapter 4 29
- Configuring the IF4IH for 29
- CompactLogix Using 29
- RSLogix 5000 29
- Section 4.2 33
- The Add-On 33
- Profile 33
- Section 4.4 36
- Project Tags 36
- Project 38
- Chapter 5 41
- Configuring the IF4IH for a 41
- MicroLogix 1500 Using 41
- RSLogix 500 41
- Section 5.2 42
- Configuring 42
- 1500 System 42
- Section 5.3 46
- Using the 46
- Ladder Sample 46
- Chapter 6 51
- Module Data, Status, and 51
- Channel Configuration 51
- Section 6.4 55
- Configuration 55
- Raw/Proportional Data 62
- Engineering Units 62
- Scaled-for-PID 62
- Percent Range 62
- 6.4.9 Channel X 64
- 6.4.10 Channel X 64
- 6.5.8 Reserved (Words 24…45) 66
- Section 6.6 67
- Determining 67
- Effective 67
- Resolution 67
- Section 6.7 68
- Update Time 68
- Chapter 7 69
- Enabling and Using HART on 69
- Table 7-1 (HART Packet 0) 73
- Table 7-2 (HART Packet 1) 74
- Figure 7-4 (Packet Ladder) 77
- 7.2.3 Packet Interval 78
- Section 7.3 79
- Sending 79
- Messages 79
- 7.3.3 Processing a Message 81
- Figure 7-6 Sending Message 82
- Figure 7-8a (Message Ladder) 84
- Figure 7-8b 85
- Figure 7-8c 86
- Figure 7-8d 87
- Figure 7-8e 88
- Figure 7-8f 89
- Figure 7-8g 90
- Figure 7-8h 91
- Figure 7-8i 92
- Figure 7-8j 93
- Figure 7-8m 95
- Figure 7-8n 96
- Figure 7-8o 97
- Section 7.4 98
- Module Specific 98
- Commands 98
- Attention 103
- Figure 7-10b 107
- Figure 7-10c 108
- Figure 7-10d 109
- Figure 7-10e 110
- Section 7.5 111
- HART Protocol 111
- 7.5.1 Message Format 111
- Chapter 8 117
- Programming Examples 117
- Figure 8-4b 121
- 8.2.1 MAIN Routine 123
- 8.2.2 PACKETS Routine 124
- Figure 8-6b 125
- Figure 8-6c 126
- 8.2.3 MSG_TO_MOD Routine 127
- Figure 8-7b 128
- Figure 8-7c 129
- Figure 8-7d 130
- Figure 8-7e 131
- Figure 8-7f 132
- Figure 8-7g 133
- Figure 8-7h 134
- Figure 8-7i 135
- Figure 8-7j 136
- Figure 8-7k 137
- Figure 8-7l 138
- Figure 8-7m 139
- Figure 8-7n 140
- Figure 8-7o 141
- Figure 8-7p 142
- Figure 8-7q 143
- 8.2.4 SRC_CHECK Routine 144
- Figure 8-8b 145
- 8.2.5 DEST_CHECKSUM Routine 146
- Figure 8-9b 147
- 8.2.6 HART_MSG Routine 148
- Figure 8-10b 149
- Figure 8-10c 150
- Figure 8-10d 151
- Figure 8-10e 152
- Figure 8-10f 153
- Figure 8-10g 154
- Figure 8-10h 155
- Figure 8-10i 156
- Figure 8-10j 157
- Figure 8-10k 158
- 8.2.7 WORD_BYTE Routine 159
- Figure 8-11b 160
- Figure 8-11c 161
- 8.2.8 HART_CHECK Routine 162
- Figure 8-12b 163
- 8.2.9 BYTE_WORD Routine 164
- Figure 8-13b 165
- Chapter 9 167
- Diagnostics and 167
- Troubleshooting 167
- 1514131211109876543210 169
- 0000000000000000 169
- Value Bits 11 170
- Description 170
- Section 9.8 171
- Inhibit Function 171
- Appendix A 173
- Module Specifications 173
- Section A.2 174
- Environmental 174
- Specifications 174
- Appendix B 177
- HART Universal and Common 177
- Practice Commands 177
- Wire Size · 3-9 183
- Wiring Diagram · 3-10 183
- Wiring Guidlines · 2-3 183
- Getting Technical 185
- Assistance 185
- Declaration of 185
- Conformity 185
Manuais e produtos relacionados com Instrumentos de medida Spectrum-controls 1769sc-HART Modules
(176 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.041 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais