Spectrum-controls 140 EHC 204 00sc Manual do Utilizador descarregar pdf (Página 18)

Counter / Flow Meter Input Module

Removing and Replacing the Terminal Block

When wiring the module, it is not necessary to remove the terminal block. However, if necessary, you can use

this procedure for removal and replacement.

1. Loosen the upper and lower retaining screws, alternating between screws. The terminal block backs

away from the module as you remove the screws.

2. Carefully pry the terminal block loose.

3. When ready to replace the terminal block, insert and tighten the retaining screws. Torque the retaining

screws to 0.46 Nm (4.1 in-lb).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 80 81

Sem comentários

Spectrum-controls 140 EHC 204 00sc Manual do Utilizador Página 18